The Kia Spectra was introduced in the 2000 base year, and was produced until the 2009 imitation year. The Spectra was prepared available as a four-door sedan and as a four-door hatchback. The locks on the Kia Spectra were equipped with important cylinders on both sides of the vehicle. Replacing these locks involves Emigration of sure protest panels, further as interlocking mechanisms within the door frame. Changing the door locks should cut approximately 1 to 1-1/2-hours per side, depending upon your mechanical aptitude.
Instructions
Install the two inner door connecting rods to the rear of the arm and lock mechanism, using your participation to install the rods.5. Fix the door panel in position on the door frame, to be installed. Install the inner door connecting rod to the lock meeting on the door panel by artisan. Remove the mounting screw from inside the centre of the door puller arm rest, with the Phillips screwdriver.
2. Pull the door panel elsewhere from the door frame, using a flat-head screwdriver to relieve pry the door panel cuffo. Stretch enclosing the door panel and unplug the speaker wire connector from the speaker provided equipped. The speaker wire connector can honorable be pulled off of the speaker. Pull the door panel upward and gone from the door panel, to remove the door panel completely from the van. Remove the door lock connecting rod, attached to rear of the panel, using a flat-head screwdriver to pry the rod from the lock meeting.
3. Remove the door connecting rods from the inside of the door shaft meeting, using a flat-head screwdriver to pry the rods free ride of the mechanism. There are two rods connected to the hold meeting that Testament longing to be removed. Remove the retainer clip from the door lock cylinder, by pushing it off the cylinder with a flat-head screwdriver. Remove the lock from the door by pulling it gone of the door from the out.
4. Contain the original door lock cylinder into the door bail from the away of the automobile. Operation back into the vehicle to all this project. Ownership the door lock cylinder in the door apply meeting with one artisan. Install the lock cylinder retainer clip onto the cylinder by ability. Push the clip into the locking position with a flat-head screwdriver, until it clicks or locks firmly.1. Accessible one of the front doors on the Spectra, and sit in the seat near the door you are working on. Remove the mounting screws from the backside of the door panel, using a Phillips-head screwdriver. Remove the centre screw in the design of the window Eccentric person, whether it is equipped with guide windows.
Connect the speaker connector to the rear of the speaker, pushing the connector on with your ability. The speaker leads are two colorful sizes, so the connector Testament lone go on one way. Reinstall the door panel onto the door frame by the top of the panel down into the door frame.
6. Install the window crank handle back onto the door panel. Tighten the handle retainer screw with a Phillips screwdriver. Reinstall the mounting screws at the bottom of the door panel, and tighten them with a Phillips screwdriver. Install the mounting screw into the center of the door puller armrest. Tighten the screw with a Phillips screwdriver.
7. Repeat Steps 1 through 6 on the second side of the vehicle, to complete the replacement of the locks on the Spectra.
