The cigarette lighter socket is a acceptable source for influence for apparent appliances such as a machine, GPS, radar detector and ambulatory ring charger. The lighter is normally on a 25- to 30-amp fuse located in the fuse box on the inside of the vehicle. The mechanism consists of two cylinders that lock the lighter in situate when it is installed. Repairing it requires distinct steps.
Instructions
1. Remove the Phillips screws securing the ash tray to the console provided the lighter is in the ashtray. Whether the cigarette lighter is not in the ashtray on the other hand in the console itself, remove the screws on both sides of the console.
Install the two bolts in the rear compartment and tighten with a socket. Install the shift indicator plate screws very as the screws along both sides of the console. Tighten with the screwdriver.
3. Lift the shift indicator plate and remove the two bolts in the backside brace using a socket. Remove the two bolts in the rear backside of the console compartment using a socket.
4. Pull the emergency brake crank all the habit up. Lift the console Sufficiently to cush access to the back of the lighter. Pull the two electrical connectors off the lighter.
5. Assign the pliers on all sides of the bottom of the lighter under the console and turn the lighter outer housing counterclockwise to unthread it. Remove the bottom tube on the lighter and pull the inner tube elsewhere down the top of the console.
6. Thread the outer tube off of the fashionable lighter. Comprehend the inner tube housing, with the influential influence contact on the backside of the tube, into the opening in the console. Thread the outer tube with the lip facing the console over the lighter from under the console. Twist the outer tube clockwise by help until it is tight Sufficiently to clench the lighter secure to the console.
7. Install the leading potency wire, with the rubber covering on the centre announce, onto the back of the lighter. Install the inklike ground wire to the post on the side of the lighter.
8. Install the console by installing the two bolts through the shift indicator opening and into the lower bracket. Tighten with a socket.
9.2. Remove the screws in the shift indicator comprehend using the screwdriver, and lift the plate up. Reaching the back of the cigarette lighter does not want completely removing the console.
