Wednesday, June 24, 2015

Look Into The Fuel Pressure On The 2005 Explorer

Fuel compel in your 2005 Explorer is supplied by a high-pressure high-volume fuel pump located in the fuel container. This pump supplies fuel to the fuel injector against at a particular vigour to right the requirements of the engine under most driving conditions. Diagnosing fuel system problems in this vehicle requires the end of a fuel-pressure-test place to verify that the fuel vigour is supplied at the licence compel.3. Reinstall the fuel pump fuse. Cycle the ignition key off and on To erect pressure in the fuel system.



Help the fuel pressure in the fuel course by removing the fuel pump fuse located in the fuse block under the hood. The fuse block is on the Chauffeur's side of the engine compartment near the firewall. The fuel pump fuse is the comprehensive fuse later to the firewall. Embarkation the engine and confess it to indolent until it stalls. Turn off the guide.


2. Screw the fuel-pressure-test establish into the approval Harbour located on the fuel censure, which sits on top of the passenger-side fuel injectors. The catechism port is protected by a plastic screw-on cap and is near the center of the rail. The fuel rail connects the fuel injectors to the fuel supply line and ensures consistent fuel pressure and volume to the injectors.


The establish is available at most Car parts stores.

Instructions

1. Note the pressure indicated on the gauge in the test set. Start the engine and note the pressure. With the ignition key on and the engine not running, the pressure should be 56 to 72 pounds per square inch. With the engine running, the pressure should be slightly higher.