The door bumpers on a Toyota 4-Runner are designed to help protect the metal on the door from dings caused by errant shopping carts or other motorcar doors flung ajar quickly. Although these mouldings can helping hand protect the SUV from damage, they're too not mere nice and many common people demand to remove them. Doing so takes a particular manner to Proceeds the double-sided tape that holds them in dwelling, on the other hand it can be done Homewards.
Instructions
1. Heat up the important borderline of the door moulding using the heat gun. Modification the heat gun on all sides of Often so you don't burn the dye. Levy a plastic putty knife between the chapter metal and the door molding. Continue pulling until the molding is completely off of the door.3. Put the eraser wheel in the drill and set the drill for a low speed.
Heat the panel until you can get the putty knife in between the two panels enough to pull the molding off of the car.2. Pull the molding back with your hands, heating the gap between the molding and the sheetmetal with the heat gun.
Run the side of the eraser wheel along the leftover tape from the molding on the door, making sure not to spin it too fast so you don't burn the paint.
4. Spray the automotive detailing spray on the door and wipe it off with microfiber towels, using a circular motion. Repeat the process for any other pieces of molding you want to remove.
