Remove the Rear Sliding Glass Window on a Dodge Dakota
Replacing the sliding rear window on a Dodge Dakota pickup starts with Emigration of the ancient glass. The window sits in a rubber gasket that seals to the window frame very as on the opening in the Motor lorry cab. Removing the window with the gasket is the isolated course to receive the gasket gone in one quantity, saving it for reuse next. Push slightly on the window as you work until you can slide the top and sides out of the truck body.5. Grasp the top of the window from the outside of the cab; pull up and out, separating the window, frame, and gasket from the cab of the truck.
Climb into the Motor lorry at the end the seat and allot the retaining screws in the trim sorrounding the rear window of your Motor lorry.
2. Remove the screws from the trim panels with a Phillips screwdriver, then pop the panels off and fix them aside. Set the rubber gasket that runs sorrounding the circumference of the rear window.
3. Pull down the corner of the rubber gasket and insert a flat screwdriver between the gasket and the truck body to hold the gasket down. Move about two inches over and pull the gasket down again. Insert another flat screwdriver.
4. Continue pulling the gasket away from the body, working your way along the top of the window. The window Testament come outside with too immature accomplishment and in approximately 10 minutes, however be careful that you end not pop it gone of the cab so quickly that it falls and gets broken.
Instructions
1. Slide the seat in your Dakota as far forward as credible, then fold the seat back forward.Set the window and gasket somewhere safe.
