Automotive thing repair is a further specialized development. Welding, sanding, alignment, and interest to naked truth are all baggage of the entity repair course. Cars are imaginary of many pieces of metal with both fasteners and spot welds to clench the parts cool. Most spot welds Testament be located on the outer fender and quarter panel to clasp on the big exterior pieces of the van. Changing a quarter panel involves drilling spot welds, cutting excess metal, and replacing the senile metal with latest metal.
Instructions
1. Congregate all the compulsory materials and be positive that the original quarter panel is in passable dispute. Describe the panel that needs to be replaced and how it is secured to be reason of the vehicle. Spot welds are used on the outer layers of the vehicle in that they are stronger than fasteners.
2. Levy gloves on before inception. Join the new panel to the body of the vehicle, using the welder. Use a low heat setting, and weld in short intervals so you do not burn through the thin metal. Alternate welding spots to allow the metal cooling time. This will prevent warping and damage to the panel.
3. Cut out the wheel well approximately 1/2 inch toward the middle of the vehicle from where the quarter panel meets the inner fender. Remember that you can trim metal that is left over, so it is safer to trim slowly than cut too much away.
4. Trim the excess metal away from the body and smooth all the edges where the new panel will be placed. Test the new panel by placing it in place to ensure a smooth fit.
5. Use the clamps to hold the new panel in place. Place a clamp every 12 inches to ensure a tight connection. Most of the accessible places are underneath and toward the rear of the vehicle.
6. Remove the panel from the target. Whether the panel is spot-welded in dwelling, employ the transaction down drill bit and drill elsewhere the spot welds. The drilled hole should be slightly bigger than the weld and it is not necessary to penetrate through both layers of the joined metal. Most panels will have spot welds every 6 to 8 inches.
7. Review all the spot welds to ensure a proper fit and strength of the bonds. A proper weld will puddle in the hole and secure the two panels together.
