Wednesday, June 10, 2015

Take Away The Drive Shaft On The Silverado For Towing

The shaft will slide out. You may lose oil from the transmission. You can plug the hole with a bushing installation tool or an old yoke.


Instructions


Removing the Driveshaft


1. Set the bound of the driveshaft. The driveshaft Testament be connected to the differential.


2. Unbolt the rear u-joint from the Partner flange. This will annex four bolts that Testament hope for a 12-point socket attached to a socket wrench.


3. Pry the rear u-joint forward out from the differential. Tape the u-joint caps before removing. The caps Testament fall off otherwise.


4. Remove the centre brace bearing with a socket wrench. This is for two piece driveshafts.


5. Pull the driveshaft out of the transmission.

Removing the driveshaft when towing your Silverado can save excess wear on your transmission and differential. The driveshaft itself is elementary to remove and re-install. Before removing the driveshaft from the Motor lorry, be decided to aim the differential yoke and the companion flange with a crayon. This Testament effect when you install the driveshaft that it is placed in the exact position it was removed from. You can also purchase a cap at the parts store that is big enough to cover the hole. This will ensure you do not lose oil.