Replacing higher parts conforming brake calipers on a Honda Conform, or any van, is a ball-buster not to be taken lightly. Whether you insist on replacing your Comply's calipers yourself, build firm you be learned all approximately the full machine and declamation with your mechanic or another Professional.
Instructions
Remove the Old Caliper
1. Void and discard brake fluid from the skillful cylinder. You should empty approximately two-thirds the proportions, or to the halfway purpose between the minimum and maximum akin.
2. Uplift and block the vehivle on a jack stand. Remove the circle to receive to receive to the caliper you need.
3. Disconnect the brake hose at the bracket mounting bolt. Plug the line with a piece of plastic to avoid contaminating the fluid.
4. Remove the caliper flange bolts and remove the caliper from the rotor or bracket. Remove the brake pads, shims, and pad retainers.
7. Reconnect the caliper mounting bolts. Connect the brake line hose, using new washers with the banjo bolt.
6. Rotate the caliper piston into the cylinder clockwise. Turn the piston back to align the piston cutout with the tab on the inner pad by so the caliper can be installed. Lubricate the boot with rubber grease so the piston boot won't twist.
Install the New Caliper
5. Connect the brake pads, shims and retainers to the new caliper. (You should probably use new ones.) Before connecting, apply a thin coat of assembly paste to the pad sides of pad shims and the back of the pads.8. Refill the master cylinder with fresh fluid if needed. Attach the wheel and lower the vehicle.
9. Check the parking brake adjustment. Pump the brake pedal multiple times to set the pads until the pedal feels firm. Test the brakes on the road.
