Lift the door panel off the door frame, and disconnect any electrical wiring connectors on the back of the door panel.4. Fix the door panel elsewhere of the course of action, and pull the plastic liner back to establish the power window regulator. Slide the glass window up by hand, and place masking tape around the top of the window frame as well as on both sides of the glass to hold it in place while you replace the regulator.
1. Unfasten the annulling battery cable of the vehicle with an open-end wrench to prevent electric shock, then remove the plastic access panels on the interior door panel by prying them off with a meager slotted screwdriver. Pry the electric window switch plate from the door panel with the screwdriver.
2. Unplug the electrical connector on the back of the electric window switch, and locate the window switch plate elsewhere of the idea. Unfasten the bolts securing the interior door panel to the door frame with a kernel Chauffeur.
3. Bargain all the screws connecting the door panel to the door frame, and remove them with a screwdriver.
The influence window regulator in your vehicle mounts inside the door panel with bolts and has the culpability of guiding the window up and down with cables. The window Engine powers the regulator; occasionally, the cables can fracture or metamorphose bound up and deposit the window from operating properly. Replacing the potency window regulator is a quite facile berth you can abundant in approximately an time or two.Instructions
5. Unplug the electrical connector on the power window motor, and unfasten the bolts that secure the power window regulator and motor to the door frame using a socket wrench. Detach the motor from the power window regulator, and remove the regulator from the vehicle.
6. Connect the new power window regulator to the motor, and attach the assembly to the door frame with bolts. Attach the plastic liner back over the door frame with masking tape, and plug the electrical wiring connectors to the back of the door panel.
7. Place the door panel onto the door frame and secure the panel with the bolts and screws. Attach the electrical connector to the back of the electric window switch and snap the switch back in place on the door panel.
8. Fasten the plastic access panels to the door panel by hand, and connect the vehicle's negative battery cable to the battery post.
