Shock absorbers perform the duplicate supply on any vehicle: they dampen the oscillations in the suspension when the vehicle hits a Knob. Mounting methods vary by manufacturer, nevertheless replacing Ford Motor lorry shocks is a accomplished do-it-yourself career as it is altogether straightforward and requires a minimum of tools.
Instructions
Remove the nut on the top mounting stud on each rear shock absorber. Again, it may be necessary to cut or break the nuts or studs to remove them.9. Remove the nut from the rear lower mounting bolt and remove the bolt.
Appliance a wrench and remove the peanut from the top mounting stud on the shock absorber. If the nut is rusted to the mounting stud, it may be necessary to saw the stud off, or use a nut splitter and crack the nut to remove it.
3. Locate the through bolt at the bottom of the shock and turn it counterclockwise with a wrench to remove it.
4. Install a new steel washer (concave side up) on the mounting stud of the replacement shock. Slide a new rubber cushion over the stud and down to the steel washer. Examine the cushion before installing it to see if one side is shaped to fit into the hole in the mounting bracket.
5. Compress the shock absorber and slide it into the mounting brackets. Replace the bottom through bolt and tighten.
6. Install a second rubber cushion on the top stud and follow that with another new steel washer, concave side down. Install the nut on the mounting stud and tighten until the rubber cushions are a bit more than slightly compressed.
7. Repeat the above Steps to replace the other front shock.
8.1. Loosen the lug nuts on a front trundle, then jack that corner of the Motor lorry up and advice it with a jack stand. Remove the tire and trundle from the Motor lorry.2.
10. Push the replacement rear shock up into the hole for the top stud and into the bottom bracket. Install new washers, cushions and a nut on the top stud, and tighten. Replace the bottom mounting bolt and nut, and tighten to complete the repair.
