For safer riding, you desideratum the windscreen at the licence heighth.
Whether you adore riding your Harley due down the course of action or to the annual rally in Sturgis, South Dakota, you demand a windscreen divide to the Correct heighth for safer riding. A windscreen as well high-reaching can collect dust, dirt or raindrops that hazy your faculty production it damaging to drive. You can reduce the windscreen down to Correct dimensions with equitable a scarce materials.
Instructions
1. Test-drive to impel the Correct heighth for your windscreen. Extract the end on your windscreen that you peep ended. You Testament decrease the windscreen down blameless below that speck.
2. Section off a elongated lot of dismal masking tape. Stick the tape in the universe aloof below where your line of vision was when riding. Before you do anything more to the windshield, take another text ride. This will confirm whether you have the masking tape in the right location. Adjust the masking tape higher or lower if needed.
3. Make a pattern of your windshield's curvature. Place a thin piece of cardboard over the windshield, and trace along the windshield's outside edge with a pencil or marker.
4. Cut out the cardboard pattern.
5. Cover your worktable with an old sheet. This will keep your windshield from becoming scratched.
6. Remove the windshield from your Harley--do this very carefully so you don't scratch the windshield or your Harley.13. Wrap your finger in a cotton cloth and dip it into some methyl ethyl ketone, also known as MEK.14.
Place the template pattern on the windshield. Trace around it on the blue masking tape with a pencil or marker.
9. Put on your safety glasses, and cut the windshield along the line you traced with a jigsaw equipped with a fine-toothed blade. Don't rush through the cutting process or the heat from the saw blade can melt your windshield.
10. Pull off some of the masking tape along the outside edge of the windshield. You need enough of the windshield exposed so you can sand the edge of the windshield.
11. Stand the windshield in an upright position. Someone should hold the windshield for you so it doesn't fall over when you begin sanding.
12. Sand the edge of your windshield with 80-grit sandpaper attached to a small block of wood. Sand the edge again using 220-grit sandpaper.
Lay the windshield on your worktable.7. Cover the windshield on both sides with blue masking tape. This will give it extra protection from getting scratched.8.
Run your wrapped finger along the edge of your windshield. This will give you a smooth finish.
15. Remove all the masking tape from the windshield. Reinstall the windshield on your Harley.
