Thursday, April 2, 2015

Replace A Caliper Inside A Nissan Altima

In a Nissan Altima, or any vehicle, replacing a brake caliper is a dicy job. Such prolongation is much top recommended for a trained mechanic. Should you glance to interchange a caliper yourself, grip it up with such an Professional beforehand.


Install the caliper into position. The pin bolts should be torqued between 16 foot pounds and 23 foot pounds.8. Connect the brake fluid hose.



Practise undeniable the motorcar is securely on the jack stand before you cause this.


2. Disconnect the parking brake cable and lock spring provided you're replacing a rear caliper. Disconnect and plug the brake hose, tossing gone the washers that were attached with the bright aficionado.


3. Unscrew and remove the caliper pin bolts so you can remove the caliper. It should swivel up out from the rotor or bracket and slide inboard off the pin sleeve.


4. Remove the brake pads, shims and pad springs.


Installing the New


5. Bring about confident the advanced caliper's piston is completely in the caliper entity. Turn the piston clockwise back into the caliper whether it isn't. Avoid poor the piston boot.


6. Coat the mounting cornerstone with a silicone based grease where the pad makes contact. Install cutting edge pads with the shims and pad springs.


7.

Instructions

Removing the Old

1. Receipts off the turn for the caliper you must exchange.


Bag modern copper washers with the blaze seed. The nut should be tightened to 12 foot pounds to 14 foot pounds.


9. Reattach the lock spring and parking brake cable to the rear caliper.


10. Bleed the brake system to remove air from it. Attach a transparent hose to the open bleeder valve and have another person depress the brake pedal. Close the valve, let the brake retract and repeat until all air is gone.


11. Replace the wheel and lower the vehicle. Pump the pedal several times to seat the brake pads, then test the brakes on the road.