Your automobile's carburettor authority valve helps to deliver fuel to the engine when carrying enormous loads. Without this, your motorcar Testament not be able to manage loads seeing it Testament shut down. Equitable go after the steps below to repair your motorcar's carburetor power valve.
Instructions
Tighten the power valve with a wrench and reposition the power valve cover and hand tighten the retaining screws. Then tighten with a screwdriver. Yu are done.
Clean the outside of the power piston and metering rod with carburetor cleaner to remove varnish. Clean the piston at the same time. At this time, go ahead and rebuild the carburetor. Replace the air horn gasket.
3. For carburetors that utilize the diaphragm type of valve, the power valve is located inside the fuel wall in the main metering block. Remove the screws retaining the power valve cover.
4. Use a wrench to loosen and remove the power valve Compare new an old power valve to ensure correct replacement.
5. Position the new gasket on the new power valve and start by hand to prevent cross-threading.1. To replace the power valves on carburetors that utilize the power valve piston or meter rod, remove the air horn from the carburetor, remove the sir horn gasket and pop the power piston and metering rod out of its position.2. Do not remove the spring that sits below the power piston.
