Shock absorbers amass you from motor response the banging and crashing while driving the Rough terrain (or, in some cases, the worn-down streets) in your Jeep. When the interval comes to alternate the shocks, the mechanism of replacing them varies depending on if you're replacing the front or rear shocks. The development can as well vary depending on what example of Jeep you bear. In any condition, you must change the shocks in pairs.
Instructions
Front Shocks
1. Exercise the Jeep's parking brake, hoist the vehicle on jack stands and remove the circle on the deadline that you're replacing the shocks on.
2. Beholding for any components within the engine that block access to the shocks' upper mounting bolts and remove them. This can embrace the battery and battery tray for the left-side shock or the air filter housing on the correct side.
3. Remove the upper mounting nuts for the shock absorber meeting using a ratchet or flare-nut wrench. Disconnect the lower bolt on the bracket connecting the lower direction arm to the meeting. Detach the link to the stabilizer bar by unbolting it from the axle bracket.
4. Disconnect and the lower balljoint from the determination arm by loosening its follower and separating it with a balljoint separator. Remove the upper bolt on the bracket for the lower check arm. Remove the shock absorber from the circle right.
5. Install the current shock absorber into the trundle hearty; due to its weight, you might longing an assistant's facilitate. Reconnect all components in reverse circuit of installation, tightening all bolts to the torque specified for your mannequin Jeep.
Rear Shocks
6. Elevate the rear limitation of the Jeep on jack stands; removing the wheels isn't compulsory. Assign the Jeep's floor jack under the differential and up thrust it enough to lift the force off the shocks.
7. Remove the mounting bolts for the shock absorbers, starting with the lower bolt, and remove the shocks.9. Install the new shock absorbers in place, tightening the mounting bolts to their specified torque.10.
The lower bolt can be accessed directly behind the wheel, pointing toward the chassis. The upper bolt is just above the wheel, pointing away from the vehicle.8. Remove the shock absorbers from the Jeep.
Lower and remove the floor jack under the differential, then lower the jack stands to lower the Jeep.
