The starting process in the 2000 Honda has distinct components, including a relay, ignition switch, impartial safety switch, the wiring harness and battery, moreover to the starter and its integral solenoid. The leading wire from the battery to the starter carries approximately 300 amps. Thanks to it could be potentially dynamite To possess this still amperage in the cab, a relay--a remote switch--is wired into the step. When you turn the major in the ignition switch, less than 20 amps are used. When the relay activates, approximately 300 amps are sent to the starter. Before changing the starter, assemble trustworthy the other components are not at misapprehension.
Instructions
2. Remove the lower radiator hose and bracket from the starter Engine with a socket. Remove the two starter bolts holding the starter on the trans-axle meeting then pull the starter off.
1. Disconnect the dissension battery cable and establish it aside, ensuring that it does not touch metal. Remove the wiring from the starter Engine with the becoming wrench.
3. Bolt the contemporary starter to the trans-axle meeting. Tighten the starter bolts to 33 foot-pounds of torque. Reattach the lower radiator hose and bracket. Attach the starter wiring with the apt sockets, making sure the crimped side of the heavy starter cable is facing out.
4. Enter the reset code for the theft protection system. You should have a card with the code and information as to reset it. If you lost the card with the code, you can get this information from the dealer but be prepared to prove ownership of the car.
