Extensive the hood and convenience an open-end wrench to remove the opposite terminal from the battery, then create the identical on the definite terminal.2. Establish the starter on the engine underneath the exhaust manifold on the passenger side of the engine, coterminous to the transmission. Honour each wire on the starter using masking tape and a permanent marker. Happily, it's not indubitable dense to exchange the starter.
Instructions
1. Capitalization a jack to pick up the front boundary of the Motor lorry then locate the frame on the jack stands.
The regular 1992 Toyota pickup has seen a group of miles over the caducity, and the starter has turned over the engine thousands of times. Most possible, the starter has already been replaced once or twice already, from wear and tear. When it goes gone again, you'll be stuck wherever you are and Testament most potential desire a tow back at ease to locate the puzzle.Then disconnect the wiring using the open-end wrench.
3. Unbolt the starter from the transmission using the 3/8-inch ratchet, extension and sockets. Carefully lower it away from the engine.
4. Place the new starter into the bell housing and verify that the drive teeth on the starter mesh with the flywheel. Then bolt it into place using the 3/8-inch ratchet, extension and sockets.
5. Reinstall the wiring on the starter motor using the open-end wrench, following the labels you noted previously as a guide. Lower the truck back onto the ground using the jack, reconnect the positive then the negative terminal on the battery using the wrench and start the truck to make sure it's functioning correctly.
