The Chevy Cobalt's ABS relay is contained within the ABS brake step check module. The Cobalt's interpretation allows the ABS relay to be accessed without also still discord. Sure, the Correct Chevy Cobalt ABS relay from Chevrolet should be installed in the Cobalt to prevent damage to the braking method.
Instructions
1. Switch off the ignition and disconnect the adverse cable on the Cobalt's battery.
2. Disinfected the world environing the tool to be replaced--the electronic brake control module (EBCM) which is connected to the brake strength modulator valve (BPMV). Carefully remove any Non-native objects and accumulated dirt from the universe.
3. Remove the retaining bolts holding the EBCM to the BPMV. Do this methodically with a clean towel before carefully seating the BPMV seal into the groove on the surface of the replacement EBCM. The new EBCM should slide right on to the BPMV.6. Reconnect the EBCM's electrical connector before reinstalling the retaining bolts and tightening them to the manufacturer's specifications.
Inspire a excellent appropriate before pulling them apart; you may have to use a bit of gentle pressure.
5. Use a little denatured alcohol to wipe down the area where the EBCM and BPMV attach to one another. Fix these aside and disconnect the EBCM's electrical connector. When re-installing the EBCM end not over handle strength when re-connecting these electrical connectors, as they tend to snap off provided pressed besides strenuously.4. Remove the EBCM from the BPMV by gently pulling them apart.
7. Reconnect the battery and program the EBCM.
