1996 Mercedes V6 DTM Rennmotor ready for installation.
Instanter that you are finished assembling the engine or annex the engine replacement on handwriting and hanging on the hoist, you are ready to install it. Installing an engine requires patience, coordination and planning. Antecedent, fabricate undeniable the intake and exhaust manifold, brackets, sensors and other accessories Testament not interfere with engine installation. This will make your final job much easier. Then follow these simple steps to help you couple the engine to the transmission and mount it in the engine compartment. Let's get started.
Instructions
1. Raise the engine 2 to 3 feet off the floor and roll the hoist next to the vehicle. Now raise the engine high enough to clear the top of the hood and roll the engine into position over the engine compartment. Once in place, you can raise the engine higher and work the angle position if necessary.
2.7. Install and tighten the rest of the engine-to-transmission bolts, align the engine to the motor mounts and fasten the through bolts or nuts. Use the crowbar to shift the engine as necessary.8.
Next, turn the torque converter on the transmission so the drain plug is facing down as well. If your vehicle has a manual transmission, apply a light coat of oil to the pilot bearing at the end of the crankshaft and a light coat of grease to the splines at the end of the transmission input shaft.
4. Lower the engine in small steps, making sure it is leveled, until the crankshaft centerline is aligned with the transmission input shaft centerline; constantly check for clearance around the engine compartment as you lower the engine.
5. Align the engine dowel pins with the holes in the transmission bellhousing and slide the engine against the transmission. You might have to use a crowbar to help you work the engine angle as you mate the engine against the transmission.
6. Fasten an engine-to-transmission bolt on each side using a wrench or ratchet and socket to fix the engine position but do not tighten the bolts. Creep underneath the car and make sure the torque converter is properly aligned with the bolt holes in the flywheel.
Support the front of the transmission on a floor jack and clear the engine compartment of any tools, bars and wires that might interfere with engine installation.3. Turn the flywheel on the engine so the large hole faces down.
Remove the hoist, chain and install hoses, fuel lines, and accessories. Follow with the rest of the engine external components.
