Along with remote starting capabilities, most fashionable Car starts bequeath users the options of keyless entry, security, anti-grind, Timber pop and a amount of further features. Chrysler PT Cruisers, close many newer cars, may be equipped with ignition immobilizers that lack bypassing to successfully first step remotely. On models mythical prior to 2005, immobilizer equipped models come with two grey keys. Remove the vehicle's under-dash panel to access the leading ignition wires. You Testament treasure the ignition, moment ignition, ornament and starter wires in a harness running down from the ignition switch. On undeniable models, the brake wire is and in this harness.
On 2005 and newer models, immobilizer equipped models are equipped with keyless entry built into the principal. Be confident to test your vehicle prior to the installation.
Instructions
1. Provided you achieve not discern the brake wire, then cast for it at the switch.2. Remove the Chauffeur's kick panel and place the vehicle's parking flare wire. This wire Testament get-up-and-go from blank to 12 volts when the parking lights are on, and Testament not alter voltage when the vehicle's dimmer switch is turned from low to giant. Scrape some gloss from the metal in the kick panel. This is where you will ground your unit.
3. Use wire strippers to remove an inch of insulation from each wire. Attach the appropriate wire from the wire harness supplied with the remote starter. Solder all necessary connections and insulate with electrical tape. Attach the starter's ground wire to the bare metal in the kick panel area with a ring terminal and self-tapping screw.
4. Drill a hole in the firewall using a 1/2-inch drill bit. Run the remote starter's tach and hood pin wires through the firewall and into the engine compartment. Find a good location to mount the remote starter's hood pin and drill a whole with a 5/16-inch drill bit. Locate the vehicle's tach wire and attach the remote starter's tach wire to it with solder and electrical tape. Route the supplied remote start antenna to the starter.
5. Program the remote start and test it. Secure the remote start unit to the vehicle using nylon wire ties.
