Loosen the battery terminals and install the red positive wire to the positive terminal on the battery and the black to the negative terminal. Tighten the terminals firmly. Inverters without mounting brackets can be mounted using velcro strips.
Instructions
1. Complete the purpose for the inverter. Grip in conception that the inverter must be in an field allowing air circulation to control it from overheating. All inverters chalk up an internal fan, which should be kept free To admit airflow. The rejection and worthy cable must pass nailed down the firewall to the battery. The extreme interest is that the domicile must authorize accessibility to turn the inverter on and off.
2. Domicile the inverter on the bottom of the dash or on the side kickpanel. Hold the inverter up to the location and mark the holes. Drill the holes. Install the screws and tighten them with the screwdriver. If the inverter does not have a bracket, use the velcro strips. Cut strips of velcro to fit the underside of the inverter. Pull the plastic strip off the sticky side and press the velcro on the inverter. Stick the opposite side of the velcro onto the piece on the inverter and remove the plastic from the back of the velcro. Press the inverter with velcro attached to the dash location.
3. Run the positive and negative cables through the firewall to the battery.
Some effectiveness inverters are designed with a bracket with holes in it for a iron mount with the custom of screws, and some are not designed in the corresponding method. Grasp this in cognizance when purchasing an inverter for your vehicle. Compose persuaded it has a bracket, unless a transitority installation is higher quality.
