A hardly any daily tools Testament aid you exchange the ignition module in your 2000 Chevy Monte Carlo.
The ignition governance module and ignition coils in your 2000 Chevrolet Monte Carlo duty as a unmarried unit to bridle the voltage and the timing of the Glimmer delivered to Everyone of the pistons in the engine block. On the contrary, you can remove the coils to exchange a failed ignition module without having to moderate the complete meeting. Worthier still, you can install the virgin ignition module in your garage with a rare banal tools hold together elsewhere of your toolbox in approximately an generation or less.
Instructions
Remove the Ignition Module
1. Disclosed the hood of your Monte Carlo. Supervene the Glimmer plug wires outlook absent of the engine In relation to the other bound where they connect with the ignition coils. The ignition coils mount on the ignition module.
2. Figure Everyone spark plug wire and ignition coil with a parcel of masking tape and a brunet marker so that you reinstall Everyone wire and coil in its resembling community on the current ignition module during the reassembly modus operandi.
3. Grab Everyone spark plug wire by the boot that connects to the ignition coil and pull it off carefully with a twisting motion.
4. Unfasten the two bolts holding each of the three ignition coils to the ignition module using a ratchet, short ratchet extension and socket.
Unfasten the ignition module from the mounting bracket using a ratchet, short ratchet extension and socket. Remove the module from the vehicle.
Install the New Ignition Module
5. Unplug the electrical connector from the ignition module. If you have a 3.8L engine model, unfasten the bolt holding the electrical connector to the ignition module first, using a ratchet and socket, before attempting to unplug it.6.
7. Place the new ignition module in position on the mounting bracket and install the mounting bolts finger tight. Tighten the bolts with the ratchet, short ratchet extension and socket.
8. Plug in the ignition module electrical connector. If you have a 3.8L engine model, fasten the bolt to secure the electrical connector to the ignition module, using the ratchet and socket, after plugging in the connector.
9. Replace the three ignition coils and tighten the mounting bolts with the ratchet, short ratchet extension and socket.
10. Connect the spark plug wires to the ignition coils. Make sure each spark plug wire snaps in place over the tower connectors on the ignition coils.
11. Close the hood.
