Bright the changes in the path of the lake backside can considerably cumulation a fisherman's flying colors proportion. One can get a lake over many caducity of fishing it, or in a short space of chronology with a fish finder. Mounting a transducer for the fish finder on the trolling Engine is a advantageous manner. This installation requires one a screwdriver and a dirk.
5. Continue clamping the transducer cable by attaching a nylon wire tie every four to six inches. If the trolling motor is a bow mount be sure To admit enough slack in the cable To admit depth adjustment.
2. Fix the transducer directly ultimate the fin on the backside of the trolling Engine.
3. Clamp the transducer to the trolling Engine with a stainless steel hose clamp. Puck transducers have a slot for the hose clamp, while skimmer transducer will require the clamp to be placed around the bracket that comes with the skimmer and is normally used by screwing to the transom. Make certain the transducer points straight down without tilting to either side.
4. Route the transducer cable around the trolling motor housing and fasten it to the bottom of the trolling motor shaft with a nylon wire tie.
Instructions
1. Purchasing a puck transducer designed for trolling Engine mounting is choicest, on the other hand provided you already own a skimmer type transducer that can very be used. With transom mount motors no slack is needed.6. Stop clamping the transducer cable at the top of the shaft and route the wire to the fish finder.
7. Use a sharp knife to trim the excess length from the nylon wire ties.
8. Attach the transducer cable to the fish finder using the plug on the cable end.
