The Chrysler Sebring is one of the extra new additions to the Chrysler family. You can either invest in a classy hardtop sedan or a convertible depending on your preference. Putting a distinct fuel vat into any Sebring base takes skill and patience.
Instructions
1. Deactivate the counteractive car-battery cable and remove the filler cap from the existing fuel vehicle. Encompass a siphoning hose to empty the remaining fuel into a fuel container. Disconnect the fuel lines and hoses on and encompassing the fuel vat. Employment a torque wrench to remove the vehicle strap bolts. Catch off the container straps and lower the fuel vat with a floor jack.
2. Deposit the late fuel container onto the floor jack and lift it up into compass under the automobile's Timber. Connect the vapour hose column to the rollover valve located on top of the fuel tank. Attach the chassis fuel tube to the Sebring's fuel filter, which is above the top left side of the fuel tank.
3. Connect the fuel filler hose to the middle of the fuel tank in the tank inlet. Adjust the hose setting to 25 lbs. Fill the tank with gas and cover it with the filler cap. Activate the negative battery cable. Check the fuel systems for any leaks by using the Chrysler DRB scanning tool.
Wrap the tank straps around your tank to hold in place.
5. Attach the front and rear bolts to connect your tank to the car's body. Tighten the strap bolts to a setting of 21 lbs. with your torque wrench. Install the fuel pump's electrical connector to allow your car to run smoothly.
6. Check the hose's connection to make sure it's on right before continuing.4. Install the fuel pump module into the body of the Sebring directly above the fuel tank. Position the fuel filter right behind the fuel tank. If there are no leaks, turn on your car and take it for a test drive.
