Drilling a gap in the exhaust can cure temporarily establish a clogged action.
Motorcycle enthusiasts sometimes drill a gap in their exhaust cylinder as a custom of forging the bike louder and giving it a bit bounteous competency due to additional airflow. A clogged exhaust can prevent a vehicle from operating. Evaluation your management laws approximately drilling holes in your exhaust thanks to the development may violate Car emission laws. While drilling the gap to receive to the mechanic is unlikely to fabricate much problem, you should be aware of what the law is before deciding to proceed. You can check search engines online or contact your local police department and ask over the phone.2.
Drilling the exhaust and may temporarily restore work so you can excite the van or bike to a repair shop. Drilling holes in an exhaust can be done in seconds.
Instructions
1.Attach a 1.5-inch drill bit to your drill with a long extension. You'll need the drill to fit about 10 inches down the exhaust pipe.
3. Insert the drill down the exhaust pipe until you feel it connect with the baffle plug at the end.
4. Drill slowly to let the bit dig in and get a grasp on the metal. Increase speed and pressure to then drill a hole through the exhaust pipe.
5. Start the vehicle to force the metal piece you just drilled out of the exhaust pipe.
6. Add additional holes as needed.
