Worn heater hoses can effect a loss of engine coolant, resulting in damage to the engine that can call for expensive repairs. Whether you mark that the heater hoses on your Ford Explorer are worn, it's first to transform them as soon as potential. Happily, this is a profession that still novice mechanics Testament be able to administer without still matter. Here's pin money the heater hoses in a 1995 to 2001 pattern Ford Explorer.
Loosen the plug and let the engine coolant drain into the container. If you're replacing just the upper heater hose, you'll only need to drain the coolant below the level of the hose.2.
Instructions
1. Remove the radiator cap. Locate the plug on the bottom of the radiator and put a clean container under the plug.Unfasten the clamps located on each end of the hose that needs to be replaced. If the clamps are the spring type, loosen them by squeezing the tabs on each side with pliers. If the clamps are the screw type, you'll need to loosen them with a screwdriver. Once the hoses are loosened, slide them up the hose, away from the connection.
3. Inspect the clamps. If they are worn, they should be replaced.
4. Slide the hose off carefully, being very carefully not to damage the connector underneath.
5. Put the clamps loosely on the replacement hose. Dip each end of the hose into engine coolant to make them slick and slide them into position on the connectors. Wipe the connectors with a clean cloth.
6. Move the hose clamps into position at least 1/4 inch away from the end of the hose, but be sure they are beyond the raised edge of the connector under the hose.
7. Put the radiator cap and plug back on and pour the drained coolant back into the radiator. Start the engine and let it warm up, then make sure the hoses aren't leaking.
