Apply headliner adhesive to the padding. Ensure the adhesive is spread evenly over the padding before applying the headliner.5. Start at the back of the cab and stick the headliner to the padding and adhesive.
Custom fit for particular makes and models, sense built headliners desire no trimming or cutting to supply a faultless fit.
Instructions
1. Remove the trim along the wrinkle of the machine's headliner with a Philips-head screwdriver. Provided screws are not visible in the trim, covered clips are used as recall. Pry the trim out from its position with a general screwdriver. Flying start at the Joint where two pieces of trim appropriate, and slowly grind along Everyone incision continuance careful not to fracture a group off.
2. Pull the existing headliner elsewhere of the car and discard. Start at one of the front corners of the headliner and pull it loose by hand. If bows or grips are used to help support the liner, remove them with a screwdriver before continuing the headliner removal.
3. Inspect the padding above the headliner. If padding is in poor condition, replace it with a thin sheet of foam. Use an automotive adhesive to apply the new pad to the interior roof of the car and allow to dry. Trim the excess from the edges with a utility knife.
4.
You can alter the headliner in your machine.Unusual is the instance nowadays when a replacement factor or Element can't be father for an American-made van. This is mainly genuine for classic and older cars. Headliners are one of the most familiar replacements an older automobile Testament necessitate.Working from back to front, slowly apply the liner while ensuring all wrinkles and air pockets are pushed out by hand. With headliner attached with the adhesive, warm the headliner with a heat gun or hair dryer to help it adhere to the padding. Heating the headliner slightly will also aid in removing wrinkles and small air pockets.
6. Re-install the trim pieces in the opposite order in which they were removed. If clips are used to retain the trim, make sure all clips are in place before snapping the trim into position. Use screws for trim requiring them, and tighten with a Phillips-head screwdriver.
