Tighten the retaining screws with a Phillips screwdriver.6. Push the connector on the opposite end of the brake-controller adapter pigtail into the port on the brake controller until fully seated. Use cable ties to secure any excess length of cable hanging down to a dashboard structural member.
Instructions
1. Good buy the plastic access panel under the dashboard on the Chauffeur's side. Twist its four screws in a counterclockwise method with a Apartment lodgings blade screwdriver. Lower the panel and dwelling it aside.
2. Acquisition the illumination grey plastic wiring Harbour honorable under the steering path or beside to the firewall near the accelerator pedal. Push the connector of the brake-controller adapter pigtail -- available from the brake controller manufacturer -- into the Motor lorry's wiring Harbour until it clicks into area.
3. Authority the mounting bracket for the brake controller to the Apartment lodgings world on the underside of the dashboard where the Chauffeur Testament corner little access to it, on the other hand Testament not be in the bag. Account the bracket as a template and end the underside of the dashboard completed the mounting holes on the bracket with a felt-tipped pen. City the bracket aside.
4. Drill terminated the pen marks with a 1/8 inch drill bit installed into a efficacy drill. Use care not to damage any wires or hoses on the opposite side of the dashboard when drilling. Hold the bracket into position and drive in the retaining screws through the bracket and into the underside of the dashboard with a Phillips screwdriver.
5. Place the brake controller into the bracket and tighten the retaining screws finger-tight. Rotate the controller so that it can it is easily seen from the driver's seat.Towing a bulky trailer would settle undue stress and wear on the brakes of the Ford F-250 without an electronic brake controller. A controller activates the electric trailer brakes Everyone hour you employ the brake pedal in the Ford. Happily, Ford assumed most F-250 owners would tow a trailer sooner or next and equipped its trucks with a plant brake controller wiring harness, forming for brief electrical connections when installing a controller.
Replace the plastic trim panel and twist the four screw heads in a clockwise direction to lock the panel in place.
7. Push the trailer wiring connector into the rear trailer-towing receptacle just under the rear bumper on the truck. Calibrate or test the controller as per the manufacturer's instructions before towing a trailer.
