Screw the wing nut onto the threaded end of the bolt, which you will need during the pulling phase. You will tighten the wing nut to pull out the dent. You will need a infrequent materials to complete this project.
Instructions
1. Bond one of the suction cups to the bolt with an epoxy specifically meant for rubber and metal surfaces. Make sure the bolt's threaded end is in the back.
2. Attach a suction cup to each end of the metal bar with the epoxy. The metal bar should look like a flattened letter "U." These additional suctions cups will rest against the car, for added stability. The rubber cup attached to the bolt will rest against the dent.
3. Drill a hole into the center of the bar to hold the bolt. Thread the bolt into the opening.
4.
Whether you bear a dent in your machine oppose, you can remove it with a dent puller. Most commercial dent pullers sell for encircling $20, on the contrary you can adjust one for a similar value provided you prefer to. This project Testament appropriate approximately 30 minutes to gross and it is relatively cinch much provided you achieve not get handyman practice.
