Your Toyota Tundra Motor lorry is equipped with airbags to supply cushion during a collision, designed to prevent determined injuries and much Passing away. Once the airbag has deployed, you exigency to moderate it for safety. Although a experienced should handgrip this, you can safely close it yourself with basic mechanics dogma and a couple of tools.
Instructions
1. Regulate your Chauffeur's side door and pull the hood fastening located near the floor under the sprint to pop your hood. Lift the hood and allot your battery at the front of your vehicle. Disconnect the antagonistic cable from the battery. This Testament prevent the current airbag from deploying at the incorrect era during installation and maybe causing an injury.
2. Gently push the airbag into the column. Screw it in place behind the steering wheel with a screwdriver.5. Place the steering column panels back in place and screw them in snugly.
Unscrew the screws from your steering column with a screwdriver and remove the panels. This will give you access to the old airbag. Unscrew the airbag from behind the steering wheel. Pull out the airbag until you see the wiring harness. Unplug it from the harness and discard the old airbag.
4. Plug the wires of the new replacement airbag into the wiring harness in the column. Manage your fuse panel located on the lower division of the sprint inside your Motor lorry. Stare at the diagram to good buy the airbag fuse. Pull the fuse out of its slot to fully deactivate the airbag system.3.
Replace the airbag fuse in the fuse panel and close it. Reconnect the negative battery cable back to its post and close the hood.
