Slide the new lock cylinder into place and install the retaining screw, or turn the key to the lock position and remove the key, to lock the lock cylinder into place.7. Reinstall the turn signal cam with the original retaining screws. Position the lock plate into place and use the lock plate tool to compress the spring-loaded lock plate.
This can effect the cylinder to stick further and prevent the chief from turning. It is big to perform this repair at the headmost message of a doubt seeing many vehicles demand the ignition chief to be in the "On" position to remove the lock cylinder. Whether the leading Testament not turn, Emigration of the cylinder is not potential without defective the steering string.
Instructions
1. Disconnect the adverse battery terminal to prevent fortuitous air bag deployment. Wait 15 minutes before removing the horn pad. This allows the capacitors in the air bag method to discharge and deactivates the course.
2. Remove the horn pad by removing the screws that attach it to the steering revolve, and unplug the horn contact and chicken air bag connector.
3. Remove the steering circle by removing the 13/16-inch retaining devotee with the 13/16-inch socket and the 1/2-inch operate ratchet in your 1/2 inch-drive socket fix. Attach the steering circle puller to the steering wheel and tighten the centre bolt on the puller until the steering spin pops clear. Sign the marks on the steering shaft and the hub of the steering shove that contour up to lock on a straight steering wheel following.
4. Remove the lock plate located last the steering revolve by screwing the lock plate belongings to the steering shaft and tightening the preserve peanut on the thing until the spring-loaded plate is depressed far enough to remove the retaining clip on the steering column with a small screwdriver. Loosen the tool To admit the plate to move up the steering shaft, and remove the tool and then the lock plate from the shaft.
5. Remove the white plastic turn-signal cam located behind the lock plate by taking out the screws attaching it to the steering column. Pull the turn signal cam up and over the steering shaft to expose the lock cylinder retaining screw or release button.
6. Remove the retaining screw or depress the release button and remove the lock cylinder from the steering column.Moderate an Ignition Lock CylinderReplacing the ignition clue lock cylinder restores the avail of the ignition gloss. Over duration, the humble internal components of the tumbler wear and stick.
Install the retaining clip and remove the tool. Line up the marks on the steering wheel and steering shaft, and install the steering wheel with the 13/16-inch nut. Tighten securely with the ratchet.
8. Reinstall the horn pad electrical connectors and screw the horn pad securely to the steering wheel. Reconnect the battery terminal. Start the engine from the passenger seat to avoid injury from the air bag if it accidentally deploys.
